SPECIFICATIONS

• POWER OUTPUT
    16 Ohms - minimum 100 watts 20Hz to 20kHz
    8 Ohms - minimum 200 watts 20Hz to 20kHz
    4 Ohms - minimum 400 watts 20Hz to 20kHz
  
• Total T.H.D. & I.M. Distortion
    4 to 16 Ohms less than .05% at any power level up to rated
     at any frequency or  combination of frequencies between 20Hz and 20kHz.
  
• Input Impedance and Sensitivity
    1 volt R.M.S. across 50kohms for 200 watts into 8 ohms on the unbalanced input.
    (note: the impedance value can be adjusted to any value up to 1 megohm-consult the   factory)
    +/- 1 volt R.M.S. across +/- 70kohms for 200 watts into 8 ohms on the balanced input.
    Input selector switch for balanced or unbalanced
  
• Frequency response and power bandwidth at rated power
    8 ohms - better than +/- .2 dB 20Hz to 20kHz
    4 ohms - better than +/- .3 dB 20Hz to 20kHz
  
• Stability
    100 % stable into any load angle 0 to 90 degrees,
     capacitive or inductive, regardless of waveshape
  
• Damping  factor
     Greater than 250 at 20Hz
  
• Noise
    Better than -120dB relative to full rated power
  

Protection Power switch/circuit breaker 4 DC power supply fuses with indicators
Gold plated input and output jacks
All steel 14 ga. Chassis, powder coat finish Peak clipping indicator LED, thermal LED
The entire amplifier circuitry (except the power output stages) is contained on one main drive card which also contains the input jacks. This means that the amplifier is completely upgradeable with future circuit improvements.

SPECIFICATIONS

• Input impedance unbalanced input 50K ohms (can be changed to suit taste)
  
• Input impedance balanced input 70K ohms each phase +/-
  
• Sensitivity for full output (40VRMS) unbalanced input 1 volt RMS (40X)
  
• Sensitivity for full output balanced input +/- 1 volt RMS
  
• Signal to noise ratio unbalanced input shorted input 80Khz filter -140DB
  swept in a 4 Hz bandwidth below full power
  
• Signal to noise ratio unbalanced input shorted input 80Khz filter -160DB
  swept in a 4 Hz bandwidth below full power
  some residual flux (harmonics) present --- see graphs page
  
• Rated output power 8 ohms (conservative)
  200 watts at less than .O2% distortion at any frequencybetween 20Hz and 20KHz
  
• Rated output power 4 ohms (conservative)
  400 watts at less than .O5% distortion at any frequencybetween 20Hz and 20KHz
  
• Output impedance --- see graphs page
• Frequency response --- see graphs page
• Weight 52 pounds per monobloc
• Retail price $2500.00 per monobloc
  

12 output devices, 2.5 kilowatt power supply, gold plated input and output connectors, welded 9not crimped) ac cord, no fan, input selector switch, peak detector LED, circuit breaker power switch, turn on delay surge relay, twin power supplies with 100,000uf of power supply filters.

Complete stability into any load know by man with no oscillations or protection interference.

home